Duck Dodgers – Marvin’s Ray Gun
Marvin the Martian’s Duck Dodgers A-1 Disintegrating Pistol is the peak of Martian military might in the 24 1⁄2th century. A simple glue together prop this one is fun to build and easy to print.
1 Glue the Body Together
- P3D_Marvin_Disintegrator_Body_Right_V1
- P3D_Marvin_Disintegrator_Body_Left_V1
- P3D_Marvin_Disintegrator_Trigger_V1
- 8mm 1.75 Filament Pieces X6
- 5mm 1.75 Filament Piece
- Insert the filament pieces into one side of the body
- Glue the trigger into one side of the body
- Put glue on the other side of the body, including where the trigger will go, and glue the two sides together
2 Put the Back Together
- P3D_Marvin_Disintegrator_BackPost_V1
- P3D_Marvin_Disintegrator_Back_V1
- Glue the back post and back into the hole on the back of the body
3 Assemble Front Barrel Together
- P3D_Marvin_Disintegrator_Barrel_Front_V1
- P3D_Marvin_Disintegrator_Barrel_Mid_V1
- P3D_Marvin_Disintegrator_Barrel_Back_V1
- Glue the three front barrel pieces together as shown
4 Add the Front Sight
- P3D_Marvin_Disintegrator_Sight_V1
- Glue the sight into the hole on the front of the muzzle
5 Assemble the Barrel
- P3D_Marvin_Disintegrator_Barrel_V1
- Glue the front of the barrel onto the barrel
- Glue the barrel into the frame in the hole, be careful of orientation! The sight should be vertical
6 Put the Stand Together
- P3D_Marvin_Disintegrator_StandBase_V1
- P3D_Marvin_Disintegrator_StandPost_V1
- Glue the post into the base
7 Done!
- Put it on the stand ready for display
